Pro-face PFXGP4501TAA Manual descarregar pdf (Página 165)

GP4000 Series Hardware Manual

165

Replacing the Installation Gasket

NOTE:

z If you are using the rear mount model, refer to Installation (see page 220).

Overview

The installation gasket provides protection against dust and moisture.

Installing the Installation Gasket

NOTICE

GASKET AGING

z Inspect the gasket periodically as required by your operating environment to

keep the initial IP level.

z Change the gasket at least once a year, or as soon as scratches or dirt become

visible.

Failure to follow these instructions can result in equipment damage.

Stage Description

1 Place the GP unit on a flat, level surface, with the display face pointing down.

2 Remove the gasket from the GP unit.

3 Attach the new gasket to the GP unit. Position the gasket in the installation

groove so that the gasket seam is at the bottom of the GP unit. First, insert the

gasket into the 4 corners, in the order shown in the image below. Then, insert

the rest of the gasket into the installation groove.

NOTE:

z The center of the GP unit bezel’s installation groove is ribbed. Make sure

you insert the gasket all the way in without catching the ribbed sections.

z When using a tool to insert the gasket, make sure the tool does not catch

the rubber gasket and cause a tear.

(GP-4301T)

Projections

Gasket

Installation

Groove

Gasket Seam

1 2 ... 160 161 162 163 164 165 166 167 168 169 170 ... 239 240

Sem comentários

Pro-face PFXGP4501TAA Manual Página 165