Pro-face FP2600-T41 Guia de Instalação descarregar pdf (Página 10)

10 Replacing the Backlight

9 Input/Output Signal Line Cautions

• All FP Input and Output signal lines must be separated from all operating

circuit (power) cables.

• If this is not possible, use a shielded cable and ground the shield.

The FP unit's backlight is user replacable.

For an explanation of how to replace the FP's backlight, please refer to the

Installation Guide.

Corresponding Replacement Backlights

*1 Use a grounding resistance of 100

Ω

, a wire of 2mm

or thicker, or

your country's applicable standard.

FP Unit Backlight Model

FP2500-T41 GP577RT-BL00-MS

FP2600-T41 PS600-BU00

Use of a different model backlight may cause a FP mal-

function or breakdown.

Please pay special attention to the following instructions when connecting the

power cord terminals to the FP unit.

• If the power supply voltage exceeds the FP's specified range, connect a

voltage transformer.

• Between the line and the ground, be sure to use a low noise power

supply. If there is still an excessive amount of noise, connect a noise

reducing transformer.

• Input and Output signal lines must be separated from the power control

cables for operational circuits.

• To increase the noise resistance, be sure to twist the ends of the power

cord wires before connecting it to the FP unit.

• The FP's power supply cord should not be bundled with or kept close to

main circuit lines (high voltage, high current), or input/output signal lines.

• Connect a surge absorber to handle power surges.

• To reduce noise, make the power cord as short as possible.

7 Power Supply Cautions

When attaching a wire to the FP's rear face FG terminal, (on the Power Input

Terminal Block), be sure to create an exclusive ground.

8 Grounding Caution

Note

Please be aware that Digital Electronics Corporation shall not be held liable by the user for any

damages, losses, or third party claims arising from the uses of this product.

Digital Electronics Corporation

8-2-52 Nanko Higashi, Suminoe-ku, Osaka 559-0031, Japan

URL: http://www.pro-face.com/

1 2 3 4 5 6 7 8 9 10

Comentários a estes Manuais

Sem comentários

Pro-face FP2600-T41 Guia de Instalação Página 10

Comentários a estes Manuais

Manuais e produtos relacionados com Monitor tátil Pro-face FP2600-T41